Tag: boating

Fall is in the air

On By David BranbyIn Commissioning & De-commissioning, Mechanical Stuff, Splendido2 Comments

Here’s to another summer sailing season at Lake Tahoe in the books! My pal Ancil and I drove up early yesterday morning to haul out Splendido for the winter. We arrived well before any of the staff was up at Obexer’s Marina, so we did our prep work (loosening the shrouds and stays) and were ready to go when Bret and Jessy fired up the Marina Bull to unstep the mast and lift Splendido gently out of the water and place her on her 38′ trailer.

Two days before, I had bade farewell to our lovely mooring at Hurricane Bay and motored down the 2-1/2 miles to Obexer’s, as they gave me permission to take an empty slip in preparation for our haul-out. On the way down, winds were 12 knots out of the east with that long fetch from Cave Rock on the east shore all the way to McKinney Bay on the west, so it was quite the rock ‘n’ rolling ride, with occasional three to 3-1/2 foot swells and water splashing over the side, which made for a lively passage.

Hauling out a 27′ sailboat like Splendido is fairly straightforward, although I’m always a bit “on point” because there’s a lot of moving parts, literally and figuratively. First, we move the boat nose first into the haul-out slip and tie her off with four lines. Then, the forklift comes in and they put a harness around the mast at the balance point near the lower spreaders. We then release the lower shrouds, upper shrouds, forestay and backstays, and they unstep the mast and place it gently on sawhorses. I then tie down all the rigging and remove the wind instruments and put them in their winter storage box. Next, we move the boat out of the slip and back it in so the stern is facing the forklift. They get it balanced on the forks, then gently lift her out and set her on her trailer. Finally, they lift up the mast once again and set it on top of the boat. We lash everything down, put the dinghy on the trailer, go have lunch at The Bridgetender in Tahoe City, and head down to the boatyard.

The ride down the hill from Tahoe (6,230 ft. above sea level) to Splendido’s winter home (4,800 ft. above sea level) was smooth and uneventful — just the way I like it. Over the next week or two, I’ll get her cleaned up and winterized, which means draining the water heater, blowing out the water lines with compressed air so there’s nothing to freeze, changing the oil and filter, topping off the fuel and buttoning her up. Ancil (who cannot help but to make constant improvements on anything that catches his eye) surprised me earlier this summer by mounting an aluminum truck storage box he’d found for free on Craigslist to hold gear, tools, and whatnot on the trailer. It looks and works great. While he was cleaning out his shop recently, he came across some steel bars and decided to fabricate, primer and paint four “mast holder” extensions that will support the mast on the lower right side of the trailer when it’s time to put on the winter cover later this fall. I can’t thank him enough for all he’s done to make sailing Splendido safer, easier, and more convenient. Thanks, Ancil!

As I write this, the aspens are beginning to turn here in the high country; the birds are flying south and the Nevada sky has turned that deep, lustrous blue that means the first blustery winds of the season are not too far around the corner. I am immensely grateful for every moment spent sailing Splendido and working on her to make her the best good old boat she can be.

I look back and recall fondly the four years(!) Debbie and I spent looking on our laptops for a boat that spoke to us and that we could afford. When we happened upon the Catalina 270 — named Boat of the Year by Cruising World Magazine the year it was unveiled — our minds were made up, and we’ve never regretted that decision. Splendido has been yar, which means lovely, balanced and quick. We learned that watching The Philadelphia Story with Katherine Hepburn (Tracy Lord) and Cary Grant (C.K. Dexter Haven) who were reminiscing about their sailboat, The True Love:

Tracy: It was beautiful – and sweet, Dex.
Dexter: Yes, yes. She was quite a boat, the… True Love, wasn’t she?
Tracy: Was, and is.
Dexter: My, she was yar.
Tracy: She was yar alright. 

Fair winds and smooth sailing. DB

Just Add Water

On By David BranbyIn Commissioning & De-commissioning, Keeping Up Appearances, Mechanical Stuff, SplendidoLeave a comment

We launch Splendido in three days, and the past six weeks have been a whirlwind of activity getting her prepped for the Tahoe sailing season. The theme this spring was, “OK, what really needs to be addressed on a well-loved 31-year old sailboat that has seen lots of use? Fortunately, my mechanical-genius pal Ancil Sigman had plenty of suggestions, as you’ll see below.

The things I intended to fix in the off-season:

  • Make a better rope with knots in it to pull up the swim ladder.

The things Ancil heartily encouraged me (and tirelessly helped me) to fix in the off-season:

  • We pulled out every inch of the original (but significantly corroded) battery cables and replaced them with beefier, brand-spankin’ new cabling, all nicely heat-shrinked, from the battery bank to the panel to the engine, inverter, etc.
  • Upgraded the boat trailer with new running lights, from hitch to taillights.
  • Pulled out two bent lifeline stanchions, straightened them, then properly re-bedded and reinstalled them.
  • Replaced all the lifelines on the boat.
  • Removed the cabin windows that were popping up (hey, 31 years is a pretty good run), re-glued them with 3M VHB tape, and scraped/re-caulked all the windows on the boat.
  • Completely rebuilt the Whale Galley Gusher pump with a new service kit (way, way harder and less intuitive than it sounds). First clue: The schematic they provide was way too low-rez to be helpful, and nothing on YouTube™ showed how to do it properly. Even the factory’s customer service lady gave us the wrong instructions. In the end, I had to call on Perplexity.ai to finally spit out the right way to do it.
  • While the icebox pump was out, I sanded, cleaned and re-fiberglassed the area under the stove with a couple layers of cloth. Turned out great. 
  • Also laid in some fiberglass cloth and epoxy on the stern shower fixture door, which had cracked with age. It looks pretty good now with a little gel coat added.
  • Replaced every seacock on the boat with new Forespar® Marelon™ seacocks. This took a ton of work because the handles don’t come off of the new ones, so you have to grind out the cabinetry in the tight spaces so you can screw the new seacocks onto the thru-hulls.
  • Replaced the cheap CDI plastic furling drum cover that broke after only two seasons (are you listenin’, CDI?) with a proper metal replacement drum cover which should have been standard issue to begin with. (Replacing this was a major pain).
  • Since the mast was down on sawhorses, we took the opportunity to service it from tip to base, checking the sheaves, fasteners, spreaders, boots, wiring, lights, etc. Ancil rigged a gypsum-board lifter to help get the 200-lb. mast back up on the boat. Thank you, Ancil!
  • Checked the steering cables looking for fishhooks (there weren’t any — whew!).
  • Tried to remove the pinkish stain around the port-side Splendido logo that happened the winter we kept the boat on the hard up at Obexer’s. Tried four or five coats of oxalic acid, several fiberglass cleaning products, Soft Scrub … nothing worked. At best, I got it to lighten maybe 15% or so. Dang.
  • Applied gel coat to nicks on the transom and elsewhere in the cabin, then wet-sanded it and polished it up.
  • Removed all the original curtains in the boat, soaked them in OxyClean and mild washing soap, re-sewed the hook-and-loop parts that had come undone, and re-attached them. They look great.
  • Removed old epoxy spills in the cabin and on deck.
  • Used 3M 4200 to glue down the bilge pump and float switch in bilge. Also, finally wired the bilge pump properly to the panel so it operates automatically and manually as well.
  • Touched up the bottom paint with blue Total Boat Krypton.
  • Put 4-5 coats of PolyGlo (amazing stuff!) on the hull, and now she looks great.

I never did get around to making a better swim ladder rope.

After some rest, I’m looking forward to a relaxing summer of fair winds and smooth sailing! DB